Quick Fix
If your washing machine restarts after the spin cycle, try these first:
- Unplug the washer for 5 minutes
- Check for unbalanced loads
- Make sure the drain hose is clear
- Inspect the lid switch or door lock
If your washing machine restarts after the spin cycle, it can leave you wondering if the cycle ever actually finishes. This issue is usually caused by load imbalance, sensor problems, or control system errors that cause the washer to repeat part of the cycle.
Here are the most common reasons your washer restarts after spinning and how to fix them.
Most Common Reasons Your Washer Restarts After the Spin Cycle
1. Load Imbalance During Spin
During the spin cycle, the washer tries to distribute weight evenly. If the load becomes unbalanced, the washer may restart the spin portion of the cycle to correct it.
What to do:
- Redistribute clothes evenly in the drum
- Avoid washing large items alone
- Mix heavy and light fabrics
Stabilize Your Washer
If your washer is restarting due to imbalance, vibration pads can help keep it stable and prevent cycle interruptions.
The idea you didn't know you needed! And now your laundry room is much less noisy
Severe imbalance can also cause your washer to shake violently during operation.
2. Faulty Water Level Sensor
The washer relies on a water level sensor (pressure switch) to determine if the cycle is complete.
If the sensor gives incorrect readings, the washer may restart because it thinks the cycle wasn’t completed properly.
What to do:
- Check for inconsistent cycle behavior
- Inspect for signs of water level issues
3. Control Board Issues
The control board manages the cycle timing and transitions.
If the board malfunctions, it may cause the washer to restart certain stages of the cycle—even after the spin cycle finishes.
What to do:
- Unplug the washer for 5 minutes
- Restart and monitor behavior
Recommended Tool to Test Components
If your washer is restarting due to a sensor or control issue, a basic multimeter can help you quickly check if parts are working properly.
Troubleshooting is made much simpler when you have a digital multimeter. Don't waste money on expensive multimeters unless it's your daily job to use one. This device is more than sufficient for your home repair needs.
In some cases, the washer may restart the entire cycle instead of just the spin portion.
4. Drainage Problems
If the washer does not fully drain water, it may restart part of the cycle to try again.
What to do:
- Check the drain hose for clogs or kinks
- Clean the pump filter if applicable
Simple Fix for Buildup Issues
Residue and buildup can sometimes interfere with sensors and drainage, causing cycle problems.
Drainage issues can also cause your washer to stop before completing the cycle.
5. High-Efficiency Cycle Adjustments
Modern washers may automatically adjust cycles based on load conditions.
This can make it seem like the washer is restarting, when it is actually extending or repeating part of the cycle.
Is It Normal for a Washer to Restart After Spinning?
Occasional restarts can be normal, especially in newer machines that adjust cycles automatically.
However, if it happens frequently or every load, it usually indicates a problem that needs attention.
When to Be Concerned
You should investigate further if your washer:
- Restarts every cycle
- Never finishes completely
- Takes much longer than normal
Final Thoughts
A washing machine that restarts after the spin cycle is usually dealing with balance, drainage, or sensor issues. Most of these problems can be fixed with simple adjustments or basic maintenance.
If the issue continues, it may point to a faulty control board or internal component.
Some washers may pause before restarting when trying to correct a problem.